Mobat-USA Communications logoMicom Logo Advanced HF radio solutions
 
    
 

Home
Accessories
Antennas & Tuners
Base Stations
Mobile Stations
Manpack
Portable Stations
High Power Amplifiers
Firm / Software
Manuals
Contact Us

 

 

 

Base Station or Portable Antenna

Model: FAA 5526

The "FANLITE" antenna is a lightweight transportable HF wire antenna intended primarily for omni-directional sky wave communications to a range of up to 2000 miles.  Short-range communication is achieved using a Near Vertical Incidence Sky wave (NVIS) configuration.  The antenna is rated for 1KW continuous operation, with a VSWR not exceeding 2.2:1 from 2 to 30 MHz.
Return to Top

Download  brochure

 


 

Folded Broadband Dipole Antenna

Model: MB-6886-88, MB-6886-90, MB-6886-89,

 MB-6886-91, MB-6886-92

The MB series are high efficiency HF folded dipole antennas covering 1.8-30 MHz with a power rating of 1 KW Voice or 250 watts in Data or "continuous duty." Compact, with a minimum horizontal tower spacing the antenna has excellent overall radiation efficiency.  Construction is of stainless steel wire elements with die cast aluminum component housings and UV resistant fiberglass spacer rods with coaxial cable connector. Lightweight but extremely robust and with a low total mass and low wind loading. Can be installed as "flat top" broadband dipole, a "sloper" or as an inverted V.
MB-6886-88, 1.8 to 30 MHz90 ft, Copperweld, 500 Watts PEP/AVG, with PL-259 connector
MB-6886-90, 1.8 to 30 MHz90 ft, Stainless Steel,  500 Watts PEP/AVG, with N male connector.
MB-6886-89, 4 to 30 MHz65 ft, Copperweld, 500 Watts PEP/AVG, with PL-259 connector
MB-6886-91, 4 to 30 MHz65 ft, Stainless Steel,  500 Watts PEP/AVG, with N male connector.
MB-6886-92 Mounting Kit
Return to Top

Download Brochure

 


 

Long-Wire Antenna

Model: TAA6030

The long-wire antenna requires less space than any dipole antenna, it is very simple to install and can be installed horizontally, in a slope, or as an inverted "L" (shown). Requires antenna tuner and good grounding for efficient operation.
Return to Top

 

 


 

HF -  Mobile Whip Antenna

Model: TAA1000 (2.4m) or FAD1400 (3.4m)

The mobile whip antennas come in two lengths, 2.4 meters (96 inches) stainless steel or 3.4 meters (3 ea. 48.4 inch fiberglass sections). The antenna bases are designed for easy installation on any vehicle. An antenna tuner must be used for operation in the HF frequency range of 1.6 to 30 MHz.
Return to Top

Download FAD1400 & TAA 1000 brochure

 


 

Broadband Vertical Antenna

Model: FAA5522

The FAA5522 is a broadband HF whip antenna intended for use with Automatic Link Establishment (ALE) capable equipment for HF communications. No external tuning is necessary for operation over the 2 to 30 MHz HF bands.
  • Minimal Maintenance requirements
  • High Reliability
  • Broadband
  • No tuning devices, no radials required
  • RF power 1 kilowatt average
  • Rugged fiberglass element and steel mounting components for harsh environments.  Wall mounting brackets or mast not included.
  • Can be mounted on a mast/pipe, tower, side of building or any other structure with proper user supplied mounting brackets.

Return to Top

Download FAA5522 Antenna Brochure

 


 

Base or Marine Antenna 

Model: MB-6886-86

M8866 vertical marine base antenna   5 kw ratingThe MB-6886-86 was originally designed for marine usage.  It has been found to be an excellent choice for extensive use as a base station antenna The antenna is useable with Automatic Link Establishment (ALE) capable equipment for HF communications. Capable of operation over the1.8 to 30 MHz HF bands. Rated at 500 watts of RF Power. Capable of being taken apart for transporting in two sections when assembled the overall length is 35 foot total. 
  • Minimal Maintenance requirements
  • High Reliability
  • Broadband
  • No radials required
  • RF power 500 watt average
  • Rugged fiberglass element and stainless steel mounting components for harsh environments. 
  • Can be mounted on steel deck plate, building or a other structure with proper user supplied mounting brackets.

Return to Top

Download Antenna Brochure

 


 

HF - SSB Wide-band Mobile and Automatic  System (WIMA)

Model: FAD1410

The MICOM WIMA is a Wide-band, Mobile, and Automatic  Antenna System. The system consists of a fast tuning, microprocessor controlled antenna tuner and a 6 ft (2.13 meter)  fiberglass whip antenna.  The tuner is rated at 125 watts for voice and limited data operation.  It covers the entire HF frequency range of 1.6 to 30 MHz with a nominal VSWR of 1.5:1.  Also available for increasing transmission range is a 12 ft 3 section fiberglass whip or a Near Vertical Incidence Sky wave (NVIS) kit.
  • 125 watts PEP
  • Single RF cable for both RF and control
  • Fully waterproof

 

  • Large memory capacity for fast tuning,
  • Compatible with all Micom-Radios

 

Additional customer installation examples in PDF format

Download brochure

Return to Top 

 

Voice duty cycle Antenna Tuner

Model:  F2265

The antenna tuner is a weatherproof, rugged, microprocessor controlled, automatic unit designed for voice operation. A single RF cable connects any Micom-2 or 3 series radio to the tuner providing both RF power and tuner control. The fast tuning design is ideal for Automatic Link Establishment (ALE) operation. Tuner also available in Olive Drab color as Model FLN2537. The Antenna Tuners meet MIL STD 810D. 
  • 125 watts PEP
  • 1.6-30 MHz operation
  • Operates at peak efficiency
  • Flexible mounting options
  • Single RF cable for both RF and control
  • Large  memory capacity with fast tuning
  • Lightweight, compact and weather resistant
  • Low level tune power
Return to Top

Download Brochure

 


 

Heavy Duty Antenna Tuner. 

Model: FLN2818

The FLN2818 antenna tuner is a heavy duty version of the F2265.  It is a weatherproof, ruggedized, microprocessor controlled, automatic unit designed for data and voice operation. A single RF cable connects any Micom-2 or 3 series radio to the tuner providing both RF power and tuner control. The automatic antenna tuner is a tuning unit designed for Automatic Link Establishment (ALE) operation. The Antenna Tuner meets MIL STD 810D. 
  • 125 watts continuous
  • 1.6-30 MHz operation
  • Operates at peak efficiency
  • Single RF cable for both RF and control
  • Large memory capacity with fast tuning
  • Lightweight, compact and weather resistant
  • Flexible mounting options
  • Low level tune power
Return to Top

 

Download Brochure

 


 

1 Kw. Antenna Tuner. 

Model: FTN6074

The FTN6074 1 Kilowatt Antenna Tuner is a fast tuning automatic antenna tuner that matches the output of the Micom-RM-1200 I Kilowatt HF radio System to a wide variety of whip an long-wire antenna's. The tuner matches the antenna impedance to the output impedance of the radio system. The fast tuning design is intended to support both conventional and Automatic Link Establishment (ALE) operation. The Antenna Tuner meets MIL STD 810F.
  • Tuning data stored in memory
  • 1.6-30 MHz operation
  • Operates at reduced tuning times
  • Weather resistant aluminum case
  • Suitable for shipboard applications
  • Suitable for conventional communications
  • Suitable for ALE communications
  • Nominal VSWR of 1.5:1 at 1.6 to 30 MHz range
Return to Top

   Download Brochure


 

Updated:19 May 2011





    
 
  

Copyright 2006 Mobat-USA